Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCyclone 3 and Can bus - Possible?
Hello, I would like to know if it is possible to build a can bus on my FPGA. I use a Neek II (cyclone 3 starter board : EP3C25F324). This FPGA has no CAN transceiver, but a RS-232 transceiver. ...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- This FPGA has no CAN transceiver --- Quote End --- But a hardware CAN transceiver is required to interface a CAN bus. Particularly, CAN is a differential bus, so single-ended RS232 can't work.
