Forum Discussion

ericmtzr's avatar
ericmtzr
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

cyclone 10GX - Programming issue

Here is the problem statement. 1. There are low pulses of ~1.7ms on the nStatus signal at every ~280ms interval. We suspect that this might be due to POR error. - Power sequence is verified as p...
FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi ericmtzr,

​

I noticed that the end customer mentioned that they're facing this issue on 6 boards out of 20 boards.

So, as to start troubleshooting and to narrow down the possible cause, have they tried to swap out the boards by substituting the 6 boards with a known-good device?


Regards,

Fakhrul


ericmtzr's avatar
ericmtzr
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

Hello, let me check with the client and as soon as I have an answer I will confirm