Forum Discussion

Puneeth_KB's avatar
Puneeth_KB
Icon for New Contributor rankNew Contributor
2 years ago

Cyclone® V with QSPI flash S70FS01GS for storage

Hi Team,

we are planning to use the serial flash S70FS01GS with Cyclone V FPGA in our new design.

however, its mentioned that in Cyclone® V SoC and Arria® V SoC Supported Flash Devices | Intel S70FS01GS flash is Incompatible due to Does not support RDSR instruction.

Also, it states that "The current list of tested and supported devices is presented below. Note that the device list applies only to the HPS Quad SPI controller, and does not apply for FPGA configuration."

Please let us know can we still go ahead and use this as mass data storage in our application. if so how support RDSR instruction is manageable.

Thank you.

Puneeth KB

Configuration

3 Replies

  • aikeu's avatar
    aikeu
    Icon for Regular Contributor rankRegular Contributor
    2 years ago

    Hi Puneeth_KB,


    It is mentioned as incompatible in the list of QSPI flash devices table. Therefore it is not recommended to use or considered in the system design.


    Thanks.

    Regards,

    Aik Eu


  • aikeu's avatar
    aikeu
    Icon for Regular Contributor rankRegular Contributor
    2 years ago

    Hi Puneeth_KB,


    I am closing the thread now.

    p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.


    Thanks.

    Regards,

    Aik Eu