Forum Discussion

AGofs's avatar
AGofs
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

Connection between 3.3V CMOS/TTL signal and 2.5V bank.

Hi everyone, I'm working with Cyclone V-GX . Is it possible to connect 3.3V signal to FPGA pin (as an incoming port), which located on 2.5V bank (without any damage to this pin)? it was possible...
AGofs's avatar
AGofs
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

Good morning Chia Ling,

Thank you a lot for a quick and efficient answer!

I think you can close the case.

Thank you once again,

AGofs.