Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

configure flex10k fpga with atmega16 processor

Hello all, Im doing a project for the uni. and at this point i sent a *.sof file through rs232 to atmega16 processor and store it in an eeprom through the TWI interface. now i need to configur...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

There are still few thing i cant seem to understand.

The Microblaster program documentation talks about configuring pld's. is it the same as configuring fpga? (specifically, Flex10 device)

More over it seems the use of byteblaster cable is necessary, is it so? because i need to build the wiring between the atmega16 processor and the up2 devices by myself.

I also can't find what is the memory requirement for the use of this software.

I looked also on the jam player, and the memory requirement is too large for use with the atmega16, so i don't think i can use those solutions.

Thank you again for your help.