Forum Discussion
nakamura_kimi
New Contributor
New Contributorchange the FPGA from 10M50DAF484 to 10M25DAF484
I am trying to change the FPGA to be installed from 10M50DAF484 to 10M25DAF484.
In that case, L3 should be changed to NC, but is it possible to leave it as GND?
Does L3 of 10M25DAF484 actually have NO bonding wire?
Thankyou
3 Replies
EngWei_O_IntelFrequent Contributor
Hi Nakamura-san
May I know what pin do you mean for L3?
Thanks.
Eng Wei
- EngWei_O_Intel
Hi Nakamura-san
In general, you can refer to link below for NC pins:
- EngWei_O_Intel
Hi Nakamura-san
We do not receive any response from you to the previous question/reply/answer that have been provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
Eng Wei
