Forum Discussion

New Contributor

5 years ago

change the FPGA from 10M50DAF484 to 10M25DAF484

I am trying to change the FPGA to be installed from 10M50DAF484 to 10M25DAF484. In that case, L3 should be changed to NC, but is it possible to leave it as GND? Does L3 of 10M25DAF484 actually have...

EngWei_O_Intel

Frequent Contributor

5 years ago

Hi Nakamura-san

May I know what pin do you mean for L3?

Thanks.

Eng Wei

EngWei_O_Intel
Frequent Contributor
5 years ago
Hi Nakamura-san

In general, you can refer to link below for NC pins:

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/solutions/rd03132006_933.html
- EngWei_O_Intel
  Frequent Contributor
  5 years ago
  Hi Nakamura-san
  
  We do not receive any response from you to the previous question/reply/answer that have been provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.
  
  Eng Wei

Forum Discussion

change the FPGA from 10M50DAF484 to 10M25DAF484

Recent Discussions

System PLL of Agliex5 PCIE example design cannot be locked after configuration

Download links not working

JTAG Chain Broken on Agilex 7-I Dev Kit

Quartus Prime Pro 25.1 fatal error during fitter: Windows "Efficiency mode" required

DO-254 Cyclone10LP / CycloneV