Forum Discussion
dhw333
New Contributor
New ContributorBurn FLASH EPCS16 successfully, but the FPGA EP4CE15 does not start after the power is turned on.
Quartus 14.1
WINDOWS 10
EP4CEF15I7N
EPCS16
MSEL:1001:AS STANDARD 3.3V
It works normally when I download the .sof file.
I replaced FLASH, FPGA, USB blaster cable and computer, and t...
NurAiman_M_Intel
Super Contributor
Super ContributorHi,
Please refer to Cyclone IV handbook for configuring using serial configuration devices. Make sure to follow the suggested steps as stated in the handbook;
Can you try to remove the resistor on the DATA line?
Regards,
Aiman
