Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Bemicro PWR_N signal and USB

Hi. I'm using a Bemicro development board for learning Verilog and VHDL and I want to make an expansion board. I have read in the manual that an expansion board can use the PWR_N signal to enable the...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Hi. I soldered a EPCS16 and works fine, but I'd like not to need to remove the bemicro from the host board I'm building every time I want to test a new configuration, so I think a good solution would be to use a switch to control PWR_N and +5V signals and detach it when I want to plug the bemicro to an USB host.