Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

arriaII GX flash program

By writing JIC file from JTAG connector,I config FPGA. It is follwing route. Jtag connector->FPGA->EPCS serial flash Can I write sof and elf file by flash programmer using the route above-m...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Hi,

You can try to use Quartus II programmer to program the .sof and .elf files in .jic file format. You can refer to these solution link on the steps to generate the .jic file from .sof and .elf files.

https://www.altera.com/support/suppo...12006_450.html

https://www.altera.com/support/suppo...32010_126.html

Refer to AN370 on how to program the .jic file. The Quartus II programmer.

https://www.altera.com/content/dam/a...e/an/an370.pdf