Forum Discussion

Rob49's avatar
Rob49
Icon for New Contributor rankNew Contributor
3 years ago

Arria 10 HPS EMIF DDR4 16-bits "Fitter was unable to place an EMIF/PHYLite system"

Hi. I'm working on a custom board using a Soc FPGA Arria 10 (10AS048E4F29E3SG) with DDR4 memory (using two components MT40A512M16(TB)062E) linked to the HPS module. Because of a yet unexplained e...
tehjingy_Altera's avatar
tehjingy_Altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi Rob49


Since this thread been resolve, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you.


If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.


Regards

Jingyang, Teh