Forum Discussion

Luk's avatar
Luk
Icon for New Contributor rankNew Contributor
6 years ago

Altera Remote Update IP core on Cyclone IV

I used the Cyclone V Remote System Update Design Example on my Cyclone IV E board, it didin't work, the application image could not be loaded by the factory configuration image. The Parameter in the ...
SreekumarR_G_Intel's avatar
SreekumarR_G_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

please create the new project with cyclone IV (which you want to use ) and add the IP of RSU using the IP catalog; Please dont add any IP files from Cyclone V to Cyclone IV project ;

here is the user guide for the Cyclone IV for your reference.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-iv/cyiv-51008.pdf

About the remote IP; as of i know there will be read_param and write_param ; and to handshake use the BUSY signal. Kindly read the remote IPO user guide for more details ;

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_altremote.pdf

thank you,

Regards,

Sree

Luk's avatar
Luk
Icon for New Contributor rankNew Contributor
6 years ago

Hello Sree,

Thank you very much.

I followed the information in the user guide to create a new project, and the application configuration could be loaded by the factory configuration.

I still have some questions:

1. If there is an error when loading the application configuration, how do I know ? To read the watchdog time-out value?

2. What is in the state register of param [111] ?