Forum Discussion

pdi_eng's avatar
pdi_eng
Icon for New Contributor rankNew Contributor
3 years ago

Altera EP4CE22F17C8N Can't Recognize silicon ID for device 1

We have build a lot of these assemblies and this board is a one off problem board. When I try to program this device in Quartus, I get the error "Can't Recognize silicon ID for device 1". I have ch...
FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
3 years ago

Hi pdi_eng,


It might be necessary for you to refer to page 219 for the guidelines on Programming Serial Configuration Devices In-System with the JTAG Interface and carefully verify that all the settings have been completed.


Here are some forum cases which may be applicable for you to look into:

Q13.1 (Error (209025): Can't recognize silicon ID for device 1) but Q11.1 works fine

Error (209025): Can't recognize silicon ID for device 1; Cyclone IV Issue

"Can't recognize silicon ID for device 1" while programming FLASH

Can't load .jic file to EPCQ device.


Regards,

Fakhrul