Forum Discussion

KWang97's avatar
KWang97
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

After watchdog for dual-config is enabled, the FPGA seems like not work properly every dozens of seconds. Why?

FPGA communicates with another FPGA with PHY chip. Normally(watchdog enable checkbox not checked), the PHY link led is always off when communication is good. While after I enble watchdog for dual-con...
KWang97's avatar
KWang97
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

But only when I enbled the watchdog did problems come, so I think there is sth to do with watchdog. I will go on looking into it and hope you could give me some solutions or comments about this if you have further findings. I would also hope could you please ask about this issue with your colleagues and maybe get some ideas. Thanks very much!