Forum Discussion

KWang97's avatar
KWang97
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

After watchdog for dual-config is enabled, the FPGA seems like not work properly every dozens of seconds. Why?

FPGA communicates with another FPGA with PHY chip. Normally(watchdog enable checkbox not checked), the PHY link led is always off when communication is good. While after I enble watchdog for dual-con...
KWang97's avatar
KWang97
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

At the end of the code, I reset watchdog together with set reconfig by assigning sl32avmm_rcv_writedata <= X"00000003"; Is this not right?

slavmm_rcv_write <= '1';

sl3avmm_rcv_address <= B"000";

sl32avmm_rcv_writedata <= X"00000003";