Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorADC+FPGA+DAC setup for predistortion
Hi, I am looking to buy the ADC12J4000EVM and DAC38J84EVM from TI. Both have an FMC connector and JESD204B interface. I am looking for a setup for predistortion and I would like to if there are...
Altera_ForumHonored Contributor
Honored ContributorHi Rosanah.
You probably need a hsmc2fmc adaptor. Then you can use can pick the altera board that supports two HSMC connectors, or 1 FMC and 1 HSMC: An adaptor can be found at: http://www.kayainstruments.com/hsmc2fmc/ (Not a recommendation, just first one I found) and TerAsic is the primary source for altera boards. http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=56&no=756 http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=139&no=745 http://www.terasic.com.tw/cgi-bin/page/archive.pl?language=english&categoryno=167&no=843 There are others, all the way up to dual Stratix V boards, depending on how much FPGA horsepower you need. www.terasic.com
