Forum Discussion

Steve9's avatar
Steve9
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

Will JTAG USB Byte Blaster II work with MAX10 at 3.0V VCCIO?

Hi, I see from USB Blaster II user guide linked below that the VCCtrgt for the MAX10 is based on VCCIO. I am using 3.0V nominal VCCIO for all the I/O banks of the MAX10. However in the user guide f...
Rahul_S_Intel1's avatar
Rahul_S_Intel1
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hi ,

I cannot provide official clarification on the above . I believe if the data sheet specifies 3V as minimum , the above configuration should work.