Where is EPCQ-L Flash located on Cyclone 10 GX Dev Kit board?

Question

I am going to replace the pre-mounted EPCQ-L flash with a new flash from other vendor on my Cyclone 10 GX Dev Kit. The schematic shows EPCQ-L is U4. However, I am not able to find it on the board.

shafiqy_intel · Answer

Hi 3000023197281.5681454609356633E12,Can you send me you board picture (front and behind)?Please make sure the serial number is clear when you take this picture.Thanks.

yong · Answer

Thanks WolfGang!

Please see the pictures attached (Cyclone 10 GX Dev Kit board front, back and serial number).

Thanks,
Yong

shafiqy_intel · Answer

Hi 3000023197281.5681454609356633E12,May I know the status of this issue? Anyway, I didn't get any of your attachment picture.Thanks

yong · Answer

Hi WolfGang,

I did send the pictures on Sep. 12. Please see the attached email.

Anyway, I have figured out where the flash is located. You can close the case.

Thanks,
Yong

Forum Discussion

Where is EPCQ-L Flash located on Cyclone 10 GX Dev Kit board?

4 Replies

Recent Discussions

SyncE clock as the reference for DDR, HBM, and FPGA control interfaces in the Agilex M-Series design

PCIe Root Complex on DK-A5E013BM16AEA

Agilex™ 7 FPGA M-Series Development Kit_HBM2e Edition_REVB2_Altera

Agilex 7 R-Tile PIPE Direct endpoint receives Set_Slot_Power_Limit, but no Config TLPs

R-tile CXL base hard IP example for the Agilex 7 M-series Dev Kit (DK_DEV_AGM039EA) does not work