When I'm trying to simulate my nios ii system using modelsim it shows this error. what should I do to overcome this?

Question

Failed Executing: make sim SPD=/home/legup/Documents/Day14/system_tb.spd ELF=/home/legup/Documents/Day14/software/build3/build3.elf ENABLE_VSIM_GUI=1 VSIM_DIR=/home/legup/altera/11.1/modelsim_ase/linuxaloem return code: 2

I'm using quartus 12.1 and modelsim 11.1 in a ubuntu system

anandraj_s_intel · Answer

Hi Damith,Refer below link which will help on the Simulating Nios II Processor Design.https://www.youtube.com/watch?v=Jw3rr76QEIchttps://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an351.pdf?language=en_UShttps://www.intel.com/content/www/us/en/programmable/support/support-resources/design-examples/intellectual-property/embedded/nios-ii/exm-simulating-niosii.htmlLet me know if this has helped resolve the issue you are facing or if you need any further assistance.RegardsAnand

Forum Discussion

When I'm trying to simulate my nios ii system using modelsim it shows this error. what should I do to overcome this?

1 Reply

Recent Discussions

MAX10 10M50 Development KIT Triple Speed Ethernet problem

About PCIe Daughter Cards for Agilex™ 3 FPGA and SoC C‑Series Development Kit

Stratix 10 FPGA Dev Kit VCCIO_FMC voltage issue

Stratix 10 Development Kit HiLo connector

Technical Assistance Request for Stratix® 10 SX SoC Development Kit (so#488775)