Forum Discussion
HUl_H
New Contributor
New ContributorWhat is the state of GPIOs of Max10 during bootup? Are they high? How much time is required to boot Max10 from internal UFM/CFM?
My IOs are pulled down in logic. But when I bootup the Max10 I see a pulse on these IOs ? What is the state of output IOs during the bootup? Can I reduce this time?
YuanLi_S_Intel
Regular Contributor
Regular ContributorHi Haseeb,
The IO is in tri-state mode during configuration.
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf (Page 28)
The configuration time cannot be reduced and it is depending on the size of bitstream.
Thank You
