Forum Discussion
eMagii
New Contributor
New ContributorWhat is the effect of nCE on passive serial configuration
We have a board with two Cyclone 10LP FPGAs connected to a processor. The processor runs u-boot/linux. The configuration will be done in u-boot. We would like to configure the FPGAs in any order, ...
NurAiman_M_Intel
Super Contributor
Super ContributorHi,
nCE is a input pin, hence it should always tied to low if you have only 1 FPGA connected to 1 flash. Kindly go to the link below for further information:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51003.pdf (page116)
Regards,
Aiman
