Forum Discussion

RT0001's avatar
RT0001
Icon for New Contributor rankNew Contributor
6 years ago

"UNKNOWN_NO_JTAG_ID" message showing while auto detect option in FPGA on JTAG mode.

Hi All, I was working with Altera Flex 6K FPGA custom board with EPC2 programming device with Altera Quartus 2 v9.0 and USB_Blaster. For testing the programming in JTAG mode, we just removed the EPC...
SreekumarR_G_Intel's avatar
SreekumarR_G_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hello Roopak,

Here is link that answer embedded for bit or byte blaster question ..

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/solutions/638.html?wapkw=flex+6000+jtag

Also below link reference for FLEX 6000 device JTAG , Can you go through page 34 in pdf , information about JATG setting on quartus

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an039.pdf?wapkw=flex+6000+jtag

Thank you ,

Regards,

Sree

  • RT0001's avatar
    RT0001
    Icon for New Contributor rankNew Contributor
    6 years ago

    Hi sreekumar.regu.girijakumari,

    Thanks for this reference.

    Let me cross check these details with the connections we made.

    Please let me know if you got any option to configure EPC2 with FLEX 6K, EPF6016ATC100-3 device.

    I tried in MAX+PLUS 2 v10.2 for this, but compilation failed and showing "current license file does not include EPF6016ATC100-3 compilation". Registered in website for license, still waiting for one week to get it.

    Regards

    Roopak