Forum Discussion

ocan's avatar
ocan
Icon for New Contributor rankNew Contributor
7 years ago

Unable to scan device chain. Cant scan JTAG chain. EMERGENCY HELP PLS!!!

Hello, I have problem with max10m08SAU169I7G . I use Quartus Prime 15.1 Lite Edition. I want to program fpga with jtag interface but when I open the quartus program; 1- I click tools => programme...
Nooraini_Y_Intel's avatar
Nooraini_Y_Intel
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hi Ocan,

Please check the nCONFIG and nSTATUS signal status if are high or low when power up the MAX 10 device. You need to scope the ​nCONFIG and nSTATUS pins on the MAX 10 side to check the correct behavior. If either one of these signals are low, then Quartus programmer will not be able to detect the MAX 10 device.

Regards,

Nooraini