Forum Discussion

Occasional Contributor

6 years ago

TSE_MAC Triple Speed Ethernet - HOW TO SET MAC FILTER ?

Hello! I'm try a TSE IP Application (10/100/1000 MII/GMII with Fifo settings) I want enable MAC FILTER on receive frames: I set TSE_MAC control register as: TSE_CTRL_FRM_ENA = 1 (control of rx...

SengKok_L_Intel

Regular Contributor

6 years ago

Hi Sir, Tested the TSE MAC filter in simulation. It work well. Did you follow the link below, section 5.3.1 for the recommended initialization sequences? https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_ethernet.pdf Regards -SK

Forum Discussion

TSE_MAC Triple Speed Ethernet - HOW TO SET MAC FILTER ?

Recent Discussions

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector