Forum Discussion

LWrig3's avatar
LWrig3
Icon for New Contributor rankNew Contributor
7 years ago

Trouble connecting DE0-Nano board to computer for programming.

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program it using Quartus 2, but I cannot communicate with the board over my Altera Blaster cable. I have installed the correct driver sof...
Vicky1's avatar
Vicky1
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi,

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program --- If you are using DE0- Nano-Soc Board then refer chapter 3 from below user manual for board settings & configuration mode,

https://www.terasic.com.tw/attachment/archive/941/DE0-Nano-SoC_User_manual_rev.D0.pdf

In case of usb blaster perform device driver update using below user guide,

https://www.intel.com/content/www/us/en/programmable/documentation/nfa1418282998564.html

Do visual check of board, clean with care also provide screenshot of programmer & errors.

Regards,

Vicky