Stratix10 E-tile how to use the nine reference clock

HI,

Your question is too generic. My best answer for you is to check out E-tile user guide doc chapter 4 that explained on E-tile refclk pins

• https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_etile_xcvr_phy.pdf

Basically NativePHY IP support refclk pin switching up till 5 pins in one NativePHY design.

• Meaning you can connect different refclk pins to different clock frequency and switch between different refclk pins in actual application test later to support different data rate

Thanks.

Regards,

dlim

Hi,

I have not hear back from you.

I hope I have clarified your doubt.

For now, I am setting this case to closure.

Thanks.

Regards,

dlim