Forum Discussion
Vivek_tiwari
New Contributor
New ContributorConfiguration Error in Stratix 10 After programming .jic file
I Tried programming Stratix 10 FPGA kit with .jic file using jtag msel pins as MSEL[2:0] as 111 and it was programmed successfully configuration error led D3 was still glowing red after that i power ...
JohnT_Altera
Regular Contributor
Regular ContributorHi,
May I know which specific development kit are you using? Is it this board https://www.intel.com/content/www/us/en/programmable/products/boards_and_kits/dev-kits/altera/kit-s10-fpga.html?
Vivek_tiwariNew Contributor
New ContributorYes this is exactly the one I am using
- Vivek_tiwari
1SG280LU2F50E2VG this is the part number written on FPGA
