Programming FPGA Flash in arria 10 soc development kit

Hi Anand,

Thanks for the reply .

I am referring an370.pdf "Using the Intel FPGA Serial flash loader with Intel quartus prime software"

https://alteraforum.com/forum/attachment.php?attachmentid=14945&stc=1

I am having aria 10 soc development kit, where EPCQ flash cant be programmed directly through JTAG.

have also referred this video by intel fpga, active serial configuration using jtag: "https://www.youtube.com/watch?v=dpsfcgnqocu" have followed the steps.

But in this video it never mentioned to instantiate altera or intel FPGA Serial flash loader (thought that programmer automatically takes care of it when jic file is used).

But in an370.pdf it is mentioned to instatntiate

https://alteraforum.com/forum/attachment.php?attachmentid=14946&stc=1

Do we need to instantiate the core, share the asmi interface, and map the pins manually or it is taken care automatically.

As per the tutorial video.

Step 1: Compile the Design

Step 2: Convert to jic file

Step3: Programmer, autodetect, change file and give jic file.

https://alteraforum.com/forum/attachment.php?attachmentid=14947&stc=1

programming was stopped at 94%

Error message:

https://alteraforum.com/forum/attachment.php?attachmentid=14948&stc=1

Please give inputs, and refrences where the process is mentioned clearly, also point out where we are going wrong.

Thanks,

Kamal Chandra