Forum Discussion

Mikel's avatar
Mikel
Icon for New Contributor rankNew Contributor
7 years ago

Problem configuring Cyclone 10 LP in Passive Serial mode

I have designed a system which uses a Max 10 (10M08SCU169I7G) with a Micron flash (MT28EW128ABA1HPN) connected to it, to configure a Cyclone 10 LP (10CL040YF484I7G) in Passive Serial mode. I am usin...
ShafiqY_Intel's avatar
ShafiqY_Intel
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hi Mike,

May I know do you use Intel Cyclone LP dev kit or your custom Board?

I suspect it might happen due to HW on board since Status_n and Config_n always pulse to low.

Thanks