Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorPlease help with the error led turned red
Hi everyone, I think I just made a big mistake. I was trying to measure signals from HSMC port of Cyclone V using oscilloscope, and I suppose I touched two pins with a probe at the same time. This...
Altera_ForumHonored Contributor
Honored ContributorDoesn't sound good.
I've blown a few pins on FPGAs in my time and each time I've been lucky and got away with just damaging the pin in question. The rest of the FPGA has been fine. In your case, it appears you have done more damage than this and potentially blown the whole chip. Which isn't good news.
