Forum Discussion

TTetz1's avatar
TTetz1
Icon for New Contributor rankNew Contributor
7 years ago

On Stratix 10 GX dev kit, the D3 error LED is red shortly after power up. Is this normal?

All DIP switches are configured as listed in the User Guide, UG-20046 (So, please don't just link the user guide again in response.) Running the dev kit in bench top mode. I've been unable to progr...
TTetz1's avatar
TTetz1
Icon for New Contributor rankNew Contributor
7 years ago
I did get a simple sof file programmed on the fpga. The important change was to set SW1 to JTAG only instead of the default, which was AVST x16. I didn't look at the D3 LED afterwards, I was just happy to get anything to work On Tue, Feb 12, 2019, 11:39 PM Intel Forums <supportreplies@intel.com wrote: