Forum Discussion
TTetz1
New Contributor
New ContributorOn Stratix 10 GX dev kit, the D3 error LED is red shortly after power up. Is this normal?
All DIP switches are configured as listed in the User Guide, UG-20046 (So, please don't just link the user guide again in response.) Running the dev kit in bench top mode. I've been unable to progr...
YuanLi_S_Intel
Regular Contributor
Regular ContributorHi Tom,
Also, can you change the switch and jumper to default settings on the board? Please let me know if problem is still existed.
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-s10-fpga-devl-kit.pdf (Page 10)
Regards,
YL
TTetz1I did get a simple sof file programmed on the fpga. The important change was to set SW1 to JTAG only instead of the default, which was AVST x16. I didn't look at the D3 LED afterwards, I was just happy to get anything to work On Tue, Feb 12, 2019, 11:39 PM Intel Forums <[email protected] wrote:
