Forum Discussion
TTetz1
New Contributor
New ContributorOn Stratix 10 GX dev kit, the D3 error LED is red shortly after power up. Is this normal?
All DIP switches are configured as listed in the User Guide, UG-20046 (So, please don't just link the user guide again in response.) Running the dev kit in bench top mode. I've been unable to progr...
YuanLi_S_Intel
Regular Contributor
Regular ContributorHi Tom,
Red LED means that configuration is error. If it goes off, by right it shouldn't light up. What about the green LED? does it light up?
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-s10-fpga-devl-kit.pdf (Page 9)
Can you show me the screenshot of error message that you got when you program the device.
Regards,
YL
TTetz1New Contributor
New Contributorhmm, I guess I can only attach one file per reply. Attached is the other file.
