Forum Discussion

CHaki's avatar
CHaki
Icon for New Contributor rankNew Contributor
7 years ago

Not seeing the JTAG scan chain on Cyclone 10LP

Here is my FPGA schematic and some screenshots of the programmer software. This is running on Windows 10. When I try to access the chip, the blue light on the USB Blaster goes on for about half a sec...
AnandRaj_S_Intel's avatar
AnandRaj_S_Intel
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi,

  1. Connect JTAG pins correctly to the download cable header. Ensure the pin order is not reversed.
  2. Check if the board is Power properly. Check POR from the Handbook.
  3. Noise on any of JTAG pins could cause JTAG programming to fail for the entire chain.
  4. Auto-detect and check once.

Refrence:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cfg/cfg_ch11_vol2.pdf

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51003.pdf

https://www.intel.com/content/www/us/en/programmable/documentation/dbl1490702915634.html

Regards

Anand