Forum Discussion

SWONG37's avatar
SWONG37
Icon for New Contributor rankNew Contributor
7 years ago

No device is detected

I was using stratix 10 and installed Quartus-pro-19.1.0.240 & stratix 10 driver. But I got an error message "Error when scanning hardware - No devices" after click "\Intel® Stratix® 10 TX Signal Inte...
Deshi_Intel's avatar
Deshi_Intel
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi Jack,

There is on board USB blaster controller chip. You can use USB type B cable to connect to on board CN1 connector to perform JTAG programming to FPGA. (refer to attached pic)

May I know what's your company name and where is your office located ? At the same time, I will try to check around to see if I can get some local FAE contact.

Thanks.

Regards,

dlim