Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

MAX II Development Board Kit - Incorrect pinout

Hi!

I noticed the pinout provided for the expansion header pins in Figure 3 from document max ii development board reference manual (Document version 6.0.1 October 2006) shows that Pin 2 from connector J3 is NC (not-connected), whereas it's actually connected to +5V in the board (as shown in the schematics provided within the same complete kit documentation - ftp://ftp.altera.com/outgoing/devkit/mii_1270n_kit-v6.0.1.exe).

I tried to find new versions of the reference manual, without success.

Any comments?

Gabriel

1 Reply

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    10 years ago

    This might be a bug in the documentation or schematic. I think you can file a service request to Altera to seek for clarification.