Forum Discussion
VNH00
New Contributor
New ContributorMax 10 development kit installer
while running board test system (bts) warning "no JTAG cable detected or selected" I am running windows 10 pro with Quartus 16.1 installed. JTAG drivers installed and are visible in device manager ...
SreekumarR_G_Intel
Frequent Contributor
Frequent ContributorOk good to know it is only BTS issue.
Actually BTS is very heavily rely on the quartus software version due to lib specific. Here is the link for setting environmental variables for BTS and use the same quartus version tool as BTS was used to build.
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/support/kdb/downloads/rd01292013_416/setting_up_environment_variables_for_gui.pdf
Thank you ,
regards,
Sree
