Forum Discussion

druva1's avatar
druva1
Icon for Occasional Contributor rankOccasional Contributor
5 years ago
Solved

local error in Transcevier

Hi, I have a local error in my rx_parallel data "0x0100009c". I set up an arria 10 transceiver with a reset controller and atx_pll for a 10GBase-R protocol so I can send 64 bits of data. I set up...
  • CheepinC_altera's avatar
    CheepinC_altera
    5 years ago

    Hi,


    Sorry for the delay. As I understand it, you have some inquiries related to the rx_enh_data_valid de-assertion in your simulation. For your information, when the rx_enh_data_valid is de-asserted, it indicates that the RX parallel data is invalid and you should ignore/discard this data. Your downstream logic should accept RX parallel data with rx_enh_data_valid = 1.


    Please let me know if there is any concern. Thank you.


    Best regards,

    Chee Pin



CheepinC_altera's avatar
CheepinC_altera
Icon for Regular Contributor rankRegular Contributor
5 years ago

Hi,


Sorry for the delay. As I understand it, you have some inquiries related to the rx_enh_data_valid de-assertion in your simulation. For your information, when the rx_enh_data_valid is de-asserted, it indicates that the RX parallel data is invalid and you should ignore/discard this data. Your downstream logic should accept RX parallel data with rx_enh_data_valid = 1.


Please let me know if there is any concern. Thank you.


Best regards,

Chee Pin