Forum Discussion

BalamuruganV29's avatar
BalamuruganV29
Icon for New Contributor rankNew Contributor
2 years ago

Is (MT28EW01GABA1HJS-0SIT) flash working on single mode or not?

I am going to design a project for AVST configuration using the flash (MT28EW01GABA1HJS-0SIT) in Agilex 7 series FPGA using CPLD MAX10 PFL IP core. For that we referred few intel development ...
Board Debug
Fpga Devkit
NurAiman_M_Intel's avatar
NurAiman_M_Intel
Icon for Super Contributor rankSuper Contributor
2 years ago

Hi,


Do you have any update for this case?


Regards,

Aiman


BalamuruganV29's avatar
BalamuruganV29
Icon for New Contributor rankNew Contributor
2 years ago

Hi,

In PFI II IP core user guide they mentioned it is also supported for single quad spi flash also.

""////////////////////

Single Quad SPI Flash
• Single quad SPI flash configuration time calculation
.rbf size for EP2S15 = 577KB = 590,848 Bytes
Configuration mode = FPP without data compression or encryption
Flash access mode = Burst Mode
Flash data bus width = 4 bits (only one quad SPI flash is used)
Flash access time = 100 ns
PFL input Clock = 100 MHz
DCLK ratio = 2

"""/////////////