Is it possible to use QSFP28 modules in the "Intel Stratix 10 TX Signal Integrity Development Kit" board? I need some information on this issue in terms of setup and software to enable this.

HI,

I can see that you are referring to a PAM4 demo youtube video.

For customer, we do provide generic board test system (BTS) software and design for customer to perform quick test on the dev kit board but it's not the same as demo design as demo design is targeted for some specific hardware setup and test purpose as shown in the youtube video.

You can refer to below link to understand the exact hardware and software tool that's available once you purchased the dev kit board.

• https://www.intel.com/content/www/us/en/programmable/products/boards_and_kits/dev-kits/altera/kits-s10-tx-si.html

For additional reference design, you can refer to below design link as well.

• https://forums.intel.com/ics-frm-article/a3g0P0000005RguQAE/highspeed-transceiver-demo-designs-stratix-10-series?articleid=a3g0P0000005RguQAE&action=view
• https://fpgacloud.intel.com/devstore/

Thanks.

Regards,

dlim