Forum Discussion

LFahem's avatar
LFahem
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Interconnects resources on Arria 10 FPGA

Hello, I am working with an Attila board on which is installed an Arria 10 FPGA component. In the Arria 10 handbook, there is a diagram of the LAB structure which is atteched below. I want to know w...
LFahem's avatar
LFahem
Icon for Occasional Contributor rankOccasional Contributor
7 years ago

Hi,

Even when I enabled hyper-retimer I didn't get the 300Mhz. The estimated Max frequency is now 280 Mhz. Actually, my project is an architrectural design based on elementary units (registers and logic equations). So, the retimer was not able to boost the frequency as expected. However, I think that I have to change the design so that I can use the full potential of the board (for example replacing multicycle paths with pipes of registers).

Thank you for your help.

Regards,

Lotfi.