Forum Discussion

Honored Contributor

8 years ago

Implementing adc on cyclone 5

implemented the module according to manual i was able to run the program successfully but i am not able to find the output may be i assigned the pins in wrong way can anyone suggest me to which pi...

Altera_Forum

Honored Contributor

8 years ago

Go through the user guide of signal-tap for more information also check the below links

https://www.youtube.com/watch?v=llodw5in4pg

https://www.altera.com/support/training/course/odsw1171.html

https://www.youtube.com/watch?v=vhkzxcexuaa

Can you attach your observed output window image.

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)

Forum Discussion

Implementing adc on cyclone 5

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector