I have a design using EP4CE15F23C9L which has 1.2 V connected to VCCINT (core voltage) instead of 1.0 V.

This design is in production and has been operational for almost 10 years. I am wondering what kind of problems/effects this will have.

Question

I believe this would have positve effects on setup timing but not sure how much - I am currently rewriting some functionality for this and setup timing is violated according to TimeQuest.

rahul_s_intel1 · Answer

Hi ,From the datasheet of Cyclone 4 ,the maximum voltage for Vccint maximum voltage is 1.8V. page no:2 of the datasheet https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-iv/cyiv-53001.pdfSo may be that is the reason for the device is not going bad, setup timing is violated according to TimeQuestWhat is the violation

Forum Discussion

I have a design using EP4CE15F23C9L which has 1.2 V connected to VCCINT (core voltage) instead of 1.0 V. This design is in production and has been operational for almost 10 years. I am wondering what kind of problems/effects this will have.

1 Reply

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector