Forum Discussion
shavian2008
New Contributor
New ContributorHow to program and boot from EPCQ1024L for the Arria 10 SoC Development Kit after power up?
I am using the Arria 10 SoC Development Kit. I could configure the FPGA with the SOF file and the programmer through the USB-BlasterII, but the content is lost once power off, and I need configure t...
JohnT_Altera
Regular Contributor
Regular ContributorHi,
You will need to change the SW4 switch to Active Serial Configuration mode first. Please follow table 22 of https://www.intel.com/content/www/us/en/programmable/documentation/iga1434736665480.html#iga1439496268303.
Then you will need to convert your sof file to jic file in order to configure the EPCQ flash content. You may refer to https://www.intel.com/content/www/us/en/programmable/documentation/mwh1410805299012.html for more information
shavian2008New Contributor
New ContributorThank you! The an370 is really helpful for my question.
BRs
shavian2008
