Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

How to get Cyclone IV GX dev board to auto-load user design?

I have been pulling out my rapidly dwindling hairs trying to figure out how to get the dev board to power up and boot my design and not the factory load. Following all the directions in the manuals ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

I have the same issue. Cyclone IV GX dev board doesn't auto-load user design, even if SW1.1 (FACTORY) is set to ON. It works if I load through push buttons.

How I'm developing a PCIe design, it shall start on power on. Does somebody knows a workaround?