Forum Discussion

YYang79's avatar
YYang79
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

how to download configuration code to Cyclone 10 dev kit board for customer's power-up configuration

Hi, I have a Cyclone 10 development kit board: DK-DEV-10CX220-A. It works well with BTS. I need to download my own configuration code either to EPCQ-L(ASx4) or to the NOR flash memories on the boar...
YYang79's avatar
YYang79
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

I generated it just following the manual. Is there any hidden point i should pay attention to? It's supposed to be very straightforward, right?

yasuhito's avatar
yasuhito
Icon for New Contributor rankNew Contributor
5 years ago

Hi,

OnBoard USB Blaster of DK-DEV-10CX220-A has Two JTAG devices.

1st device is CFG MAX10(10M08SA) for PFL.

2nd device is Cyclone 10 GX(10CX220Y).

How to

(1) Open Programmer.

(2) Click "Auto Detect". You can find "10M08SA" and "10CX220Y".

(3) Select "10CX220Y"

(4) Click "Change File". and Open .jic file.

(5) Check "Program/Configure".

(6) Click "Start".

OK?

  • YYang79's avatar
    YYang79
    Icon for Occasional Contributor rankOccasional Contributor
    5 years ago

    Hi,

    Thank you for your response. Yes. That was the procedure that i did.

    • yasuhito's avatar
      yasuhito
      Icon for New Contributor rankNew Contributor
      5 years ago

      Hi,

      "10M08SA" is not included in the above picture "SLF_error.png".
      Do not delete "10M08SA".
      It looks like an attachment picture.