Forum Discussion

Occasional Contributor

5 years ago

how to download configuration code to Cyclone 10 dev kit board for customer's power-up configuration

Hi, I have a Cyclone 10 development kit board: DK-DEV-10CX220-A. It works well with BTS. I need to download my own configuration code either to EPCQ-L(ASx4) or to the NOR flash memories on the boar...

YYang79

Occasional Contributor

5 years ago

Hi Aiman,

i have contacted you before. My issue is still unsolved. per you request i attached the pictures.

NurAiman_M_Intel

Super Contributor

5 years ago

Hi,

Apologize for the delay in response.

JIC programming failure might be due to TCK frequency of the USB blaster II. Try to change it to 6MHz.

On top of that, please ensure to change switch to AS switches. Can refer userguide below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-c10-gx-fpga-devl-kit.pdf

Thanks.

Regards,

Aiman

YYang79
Occasional Contributor
5 years ago
Would you please let me know how to change it to 6MHz?

Forum Discussion

how to download configuration code to Cyclone 10 dev kit board for customer's power-up configuration

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

CXL 2.0 support on the NEW Agilex™ 7 FPGA I-Series Development Kit (2x R-Tile and 1x F-Tile)

Agilex5 HPS2FPGA usage

Mandelbrot viewer on Cyclone V - Platform Designer layout