How to change the Signal Type of "locked" signal from INTEL PLL FPGA IP from conduit to reset output( Cyclone 5 board)?

Hi,

I have been trying to connect the "locked" signal (conduit) of Intel PLL IP to "my_reset"( reset input) signal of custom IP in platform designer 18.1.

The locked signal type is conduit by default and there is no option to change the type. A conduit signal cannot be connected to non- conduit signal in qsys.

I want to connect this to my reset signal which is not conduit type.

1) Is there a way to so without modifying the signal type of "my_reset"?

2) I want to change the type of locked signal from IP, but i can't find the option. Is there a way to change the signal type inside INTEL PLL FPGA IP for Cyclone 5 device?

Thanks

SBilg