Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Help on how to use DC +5V (VCC5) and GND pins

I wanted to use the DC +5V (VCC5) pin on the expansion header to connect to my breadboard but I am not sure how to do it. The manual only states that the board has 8 pins that are either a source/gnd pin and their location on the board. In VHDL would I assign GPIO_0[11] GPIO_0[12] as output pins?

2 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    15 years ago

    Sorry about that. I have the DE2 board and the Cyclone II EP2C35F67C6N. I'm not sure what you mean by connection number.