Forum Discussion

SKacc's avatar
SKacc
Icon for New Contributor rankNew Contributor
6 years ago

FPGA programming verification

Hi Team

I am using Arria V FPGA in my design. How to confirm if I program FPGA successfully?

I know FPGA_DONE is driven HIGH. Is there any checksum king of verification?

Regards

Srikanth Kacchu

2 Replies

  • NurAiman_M_Intel's avatar
    NurAiman_M_Intel
    Icon for Super Contributor rankSuper Contributor
    6 years ago

    Hi,


    Thank you for contacting Intel community.


    CONF_DONE is HIGH is enough for you to know that you have program the FPGA successfully. If there is error, CONF_DONE will be LOW or nconfig-nstatus is LOW. And INIT_done will be high when entering user mode.


    Thanks.


    Regards,

    Aiman


  • NurAiman_M_Intel's avatar
    NurAiman_M_Intel
    Icon for Super Contributor rankSuper Contributor
    6 years ago

    Hi,


    If there is no further request needed, i will proceed to close this case. If you have other question, you are always welcome to post a new case.


    Thanks.


    Regards,

    Aiman